Production MovieNights - Revision history

Arianam: /* Deflating and Breakdown */

2024-01-25T20:24:07Z

Deflating and Breakdown

← Older revision		Revision as of 16:24, 25 January 2024
Line 69:		Line 69:

	=== '''Deflating and Breakdown''' ===		=== '''Deflating and Breakdown''' ===
			For deflating the screen, each man should have a mid-strap to keep the tension on the screen to fold it in half.
			*Turn off the air pump.
			*As the screen is deflating pull mid-straps to the rear to ensure the screen folds in half (clamshell).
			*Once folded in half open the vents and allow the screen to completely deflate.
			*Disassemble the FOH and sound while the screen fully deflates.
			*After the screen is fully deflated, fold in half again width-wise twice.
			*Then fold again lengthwise ensuring the sock is on the bottom.
			*Then roll the screen from the fold to the sock, keeping the sock outside.
			*Place the screen in the bag and ratchet the bag to hold it together.

	== <big>'''Two Story Screen'''</big> ==		== <big>'''Two Story Screen'''</big> ==

2024-01-25T20:23:21Z

Front of House (FOH) and Sound

← Older revision		Revision as of 16:23, 25 January 2024
Line 61:		Line 61:

	=== '''Front of House (FOH) and Sound''' ===		=== '''Front of House (FOH) and Sound''' ===
			*With the 12/3 cable we laid down before we inflated the screen plug on end into the generator or power that has been provided for you
			*The other end will plug into the yellow waterproof surge protector(puck).
			*Plug the 50’ snake into the Yellow puck.
			*Connect the snake to the rack using the cables preset in the rack (Power and audio)
			*Connect the Speakers, Subwoofer, and mic to the snake.
			*Pull power for speakers and subwoofer from the yellow puck.

	=== '''Deflating and Breakdown''' ===		=== '''Deflating and Breakdown''' ===

2024-01-25T20:22:51Z

Inflating the Screen

← Older revision		Revision as of 16:22, 25 January 2024
Line 55:		Line 55:

	=== '''Inflating the Screen''' ===		=== '''Inflating the Screen''' ===
			Each man takes a mid strap to guide the screen up.
			*Attach the air pump to the air vent “sock”
			*While holding the mid straps turn on the air pump.
			*Once fully inflated adjust the straps to straighten out the screen to ensure a level, straight, and direct viewing of the screen.

	=== '''Front of House (FOH) and Sound''' ===		=== '''Front of House (FOH) and Sound''' ===
	=== '''Deflating and Breakdown''' ===		=== '''Deflating and Breakdown''' ===

2024-01-25T20:22:21Z

Anchoring

← Older revision		Revision as of 16:22, 25 January 2024
Line 50:		Line 50:
	**Feed the straps through the bottom of the ratchets while in the closed position and out through the top. Then pull the slack out of the strap and back towards the screen.		**Feed the straps through the bottom of the ratchets while in the closed position and out through the top. Then pull the slack out of the strap and back towards the screen.
	**Take all the slack out the straps		**Take all the slack out the straps
			**Ratchet the bottom straps tight
			**For the top straps pull about 1 to 2 arm lengths out. (6-10’), then ratchet them so the slack doesn’t slip back.
			'''MAKE SURE ALL RATCHETS ARE IN THE CLOSED AND LOCKED POSITION'''

	=== '''Inflating the Screen''' ===		=== '''Inflating the Screen''' ===

2024-01-25T20:21:30Z

Anchoring

← Older revision		Revision as of 16:21, 25 January 2024
Line 44:		Line 44:

	* '''Water Barrels'''		* '''Water Barrels'''
			**Using a minimum of 1 water barrels per anchor point, using the 1” ratchet straps secure the barrels together.
			***Secure a carbineer or a shackle on the 1” ratchet strap
			***Attach the screen ratchet strap to the carabiner or shackle
			**Ensuring the straps are connected to the screen, attach the straps to the Screen ratchets
			**Feed the straps through the bottom of the ratchets while in the closed position and out through the top. Then pull the slack out of the strap and back towards the screen.
			**Take all the slack out the straps

	=== '''Inflating the Screen''' ===		=== '''Inflating the Screen''' ===

2024-01-25T20:17:34Z

Anchoring

← Older revision		Revision as of 16:17, 25 January 2024
Line 37:		Line 37:
	Whether you are using water barrels or stakes the distance and placement are the same.		Whether you are using water barrels or stakes the distance and placement are the same.

	*~~===~~ Stakes ~~===~~		* '''Stakes'''
	*~~===~~ Water Barrels ~~===~~		** 1 stake per corner. Ensure top and bottom ratchet are staked together for each corner.
			** The position of the achor points is important. Each anchor point is 16’ away from the screen.
			** The front anchor points are 16’ away from the screen and 7’ over creating a 45degree angle.
			** The rear anchor points are 16’ straight back.

			* '''Water Barrels'''

	=== '''Inflating the Screen''' ===		=== '''Inflating the Screen''' ===
	=== '''Front of House (FOH) and Sound''' ===		=== '''Front of House (FOH) and Sound''' ===

2024-01-25T20:14:02Z

One Story Screen

← Older revision		Revision as of 16:14, 25 January 2024
Line 37:		Line 37:
	Whether you are using water barrels or stakes the distance and placement are the same.		Whether you are using water barrels or stakes the distance and placement are the same.

	=== Stakes ===		*=== Stakes ===
	=== Water Barrels ===		*=== Water Barrels ===
	=== '''Inflating the Screen''' ===		=== '''Inflating the Screen''' ===
	=== '''Front of House (FOH) and Sound''' ===		=== '''Front of House (FOH) and Sound''' ===

2024-01-25T20:13:12Z

Anchoring

← Older revision		Revision as of 16:13, 25 January 2024
Line 35:		Line 35:

	=== '''Anchoring''' ===		=== '''Anchoring''' ===
			Whether you are using water barrels or stakes the distance and placement are the same.

	=== Stakes ===		=== Stakes ===
	=== Water Barrels ===		=== Water Barrels ===

2024-01-25T20:12:51Z

Securing Vent Covers

← Older revision		Revision as of 16:12, 25 January 2024
Line 29:		Line 29:

	=== '''Securing Vent Covers''' ===		=== '''Securing Vent Covers''' ===
			There are usually 4 vent covers on a 2 story. There are 2 on top front left and right, and 2 side vents.
			*First zipper all inner vents.
			*Secure vents with the velco
			*Ensure the vents are sealed and flush with the screen.

	=== '''Anchoring''' ===		=== '''Anchoring''' ===
	=== Stakes ===		=== Stakes ===

2024-01-25T20:12:23Z

Laying Out Equipment

← Older revision		Revision as of 16:12, 25 January 2024
Line 24:		Line 24:

	=== '''Laying Out Equipment''' ===		=== '''Laying Out Equipment''' ===
			* unroll the screen away from the edge across the tarp. Leaving the air vent “sock” on the edge of the tarp and the 12/3 cable under the screen.
			* “sock” (air intake valve) remains on the edge.
			* Once the screen has been unrolled and unfolded length-wise. Unfold the screen twice width-wise making sure the screen remains folded in half (clam-shell).

	=== '''Securing Vent Covers''' ===		=== '''Securing Vent Covers''' ===
	=== '''Anchoring''' ===		=== '''Anchoring''' ===